Fuzz

Same here, every first time i connect to this site in a couple days, i get a panic screen from the browser, i have to kill the page then i can reconnect properly. This never happens on trusted websites, only here or on very shady pages that overloads you with popups.

Doesn't the bends undo themselves when you boil it to clean it ? Or is just alcohol enough ?

If you rip out the shell of the diaper and throw the absorbent material (s.a.p. and paper pulp) in the compost it will compost pretty quickly. Way better for the environnement, for the house smell, and the empty shell weight practically nothing.

Applying lotion or baby oil to the area before wearing could help as a barrier. Maybe a long soapy bath after cleaning up in the shower ?

Hi folks, I've been fiddling with caths and stents for a while, with the infos i learned here in the different threads. However, my many tries, i can't find the right stent shape, length and angles that works for me. So i'm searching for a solution to mould or print my urethra shape. I'm thinking about blocking the balloon of a cath with some rigid tubing over the ballon, then cleaning, inserting and filling the inflate line with some sort of liquid/medical glue that will preserve urethra shape after setting. I'd make sure the ballon isn't inflated before letting it sit so i don't end up with it stuck inside. I understand the risks, if the balloon fills a little, it will get stuck. Anyone has an idea on how to achieve this with some relative safety ? Thanks!

Has anyone with female genitalia (cis women, trans men or any people with vaginas) ever tried an holey foley? I'd love to read theses people's experiences with caths or holey foleys, would love to experiment on some risk aware partners, I'm mostly concerned by the increased possibilities of getting UTIs .

Thanks for the reply and topic with so much good information! But is the 90 degrees angle hard to push in and out? I wanna try it but fear it could get stuck...

The 3 angles stent (the top one in my post) ended up totally inside the bladder. The second one I'm not sure,I think it entered just partially. This is a risky type of play but they were usually easy to recover with the fishing line. I just pull very slowly while my bladder is full, and I'm usually either able to put it back in place or to it get it out in a splash! Edit: Got a prototype stuck inside earlier today, had blood when i was pulling, so I went to the ER but i was finally able to recover it peeing and pulling in the restroom. I hope i didn't hurt anything too bad down there, everything works normally for the moment. So I'm insisting on "do this at your own risk". Not sure i'll give this a go again, I'll just revert back to holey foleys.

Hi! So having some experience with holey foleys and reading about cathdiap's stent I decided to give it a try. Made a couple ones, I feel I'm close to a working design but they keep migrating in my bladder when I sleep. Anyone has suggestions for improvement to stop the migration? Should I try shorter between bends or silicone cath as a base instead? 20Ga silicone coated latex Cath with three bends: And 20Ga silicone coated latex Cath with Two 45° bends with a hollow bead stopper.