Search the Community

Everything I have said about my stent in this topic or on this forum is my own personal experience and most likely will not apply to you. I have been using stents for many years now and for me it's by far the best solution to become incontinent. I can keep it in as long as I like my incontinence. Most of the times I use it three to four days at a time, but sometimes, like now, I can't get enough of that helpless feeling and keep it in for a few weeks. For me it is completely safe, it never hurts and I never had a UTI using my stents. Using stents I become totally incontinent, so I dribble all the time when standing or walking around. But when I sit the urethra is closed by the pressure of the diaper between my legs so the dribbling stops and the pee stays in the bladder. If I remain seated for a long time the pressure in the bladder keeps building up untill it gets too high. Then I start having urges causing the urethra to suddenly give way so I start peeing large amounts in my diaper. The same goes for caughing, laughing or sneezing while sitting in my diaper. The pressure caused by these actions forces the urethra to open up for a while and let me pee small amounts. If I stand up from my chair my bladder will start emptying itself completely and sometimes it means I have to change immediately. In bed my incontinence is different again. If I am lying motionless the driblling also stops and my bladder starts acting like a reservoire again untill I start having slight urges. Then my bladder starts emptying immediately, but not completely. Sometimes I wake up from having these urges, but most of the times this seems to happen while I am asleep. If I turn around, caugh or sneeze I also wet myself a little. Getting out of bed my bladder completely empties itself and then the dribbling starts again. So being totally incontinent you will experience not only constant dribbling, but also urge and stress incontinence depending on the position you're in. But one way or the other, you will never be able to reach a toilet without an empty bladder (and a wet diaper). Apart from urinary incontinence I sometimes experience some other (un)pleasant side effects of using stents. Due to the fact that the stent is also inside the prostate it will gently massage it when you are walking. It has happened a few times that I had orgasms in public. The excitement of being incontinent, the pressure of the wet diaper between my legs and the prostate being massaged all the time, is sometimes simply too much to handle. Wearing a stent for extended periods also affects the strength of my anal sphincter. That's why I have had several accidents doing number two in my diaper when I wasn't anywhere near a toilet, also in public!! And that kind of incontinence is not exactly what I like, but it happened nonetheless.

I'm thinking alot about getting a Memokath or similar stent inserted by a professional to create a permanent, but reversable incontinence. (that might needs replacement every few years) Thinking about the one mentioned in the big "stent thread" - https://pnnmedical.com/memokath/memokathtm-045-urethra/ Have anyone ever done something like that? Are doctors willing to do it? I'm "officially" fully incontinent because of an accident. So my medical journal does not exactly fit in with getting one inserted, so I'm considering doing it abroad, maybe as "medical turism" out of country. But it might get expensive, and a problem if the stent starts migrating! Anyone have any experience with this, or some of the same thoughts?

First of all, sorry if it is not understood perfectly, I have written it in my language and I have used a translator I will try to give an idea of a stent design for those girls on the forum who have asked and are interested in having a stent with the possibility of removing it at any time. This is an idea for a girl's stent design that came to my mind when thinking of new ways in boy's stents that have been said on this forum over the years. This design is based on a somewhat special type of catheter. They are more difficult to find than Foley catheters, but they are much more suitable and comfortable for this use. Necessary materials - Malecot catheter of a small size. 6CH to 12CH. But it will depend on your urethra and the clamping ring. I'll explain later. - Long metal rod. 10cms or more. Slightly flexible and with a round tip. - Pair of scissors - Ring suitable for earring. Of this style or similar (as thin and small as possible). This is an example, but it can be of several designs to choose. - Measuring tape. - Alcohol and equipment to disinfect - Lubricant for catheter use. Information The idea is to have a stent that is held at one end by the wide part of the catheter, and at the other end by a metal piece. The total length of the stent will be individual for each person in order to avoid slippage and irritation. This stent can be easily removed, but for this the corresponding accessory will be necessary, so if you are away from home and do not carry that accessory with you, you will have to carry enough diapers. This occurs because the tip of the Malecot catheter remains open if the rod is not inserted, preventing it from coming out and at the same time allowing urine to escape through it. Before proceeding I recommend testing the force necessary to open and close the tip and check (if it comes) the width of the rod that comes with the catheter (we will probably use another). The force required should not be too much. If so, use a thinner rod. Now, once we have everything, we go with the steps to follow. Remember that everything must be perfectly sterilized. Steps to follow 0- I recommend opening the vaginal opening with a speculum or keeping the labia open in some way for comfort and to avoid contaminating the catheter. I recommend doing it somewhere that allows you to lie down and that you can get wet. Then we clean the vagina area and use some type of disinfectant. 1- Measure the length of your urethra and check the method for insertion and removal of the stent: This step is easy but important. If our catheter did not have a rod, we will use one of our own to keep the tip closed, inserting it to the bottom of the catheter and using force with 2 fingers (to prevent the rod from coming out). We probably need both hands for this, that is why it is important that we have our vaginal lips open without using our hands. We lubricate the catheter and urethra. Now what we will do is insert the Malecot catheter into the urethra gently without twisting. It should go in smoothly. If we notice pain or that it does not go in smoothly, it is because we are inserting it incorrectly or we are using a size that is too large. It may also be that you are not relaxed. For this just try to pee and focus on it, that helps a lot. It should be inserted about 50mm. You will notice that it has entered because you will notice that it passes through the urethral sphincter and it may begin to pee out. I recommend inserting at least 10 mm more to ensure that the tip is inside the bladder. Now stop straining with your fingers. With one hand hold the catheter inside and with the other pull out the rod. The urine should now flow rapidly to the outside. What we will do now is measure the exact length of your urethra. We gently pull the catheter out until we notice that it cannot come out (the tip is found open) We mark the catheter at the entrance area of the urethra with a pen. The measurement marked in the image should be around 40mm, but it depends on each person. We put the rod back to the bottom. Remember to apply force with 2 fingers on the catheter so that it does not go inwards. Once the catheter tip is closed, you can gently pull it out and remove it. 4- Catheter modification: This part is the most difficult because it depends on the materials you are using. The first thing to do is cut the catheter a little beyond the marked area as shown in the image. I recommend cutting about 3mm more than the mark made previously. Now we will put a piece to prevent the catheter from migrating towards the bladder and staying in place. We will use the metal ring looking like this: It is important to choose a ring that, when passing through the stent, does not completely block the opening of the tube and at the same time allows the entry of the rod. A good idea is to go through the stent a little laterally so that you can later insert the rod more easily and also control the type of urine outflow. If you are having trouble finding a ring or part to place here, it may be a better idea to increase the size of the catheter. We will test one last time that the rod can be inserted correctly with the ring on and that the tip can be opened and closed without problems. I recommend marking the rod with some mark when the tip is fully closed, to have a reference and to be able to remove the stent in the future in a controlled way. 3- Stent placement: Properly sterilize and lubricate your stent. This last step is similar to step 1 but this time we will apply the force of the fingers in the part where the ring is. We insert in the same way or we can help ourselves with the other hand to open the lips: Push the stent all the way in, even if you feel the urine coming out before reaching the end. Remember that the length is appropriate for your urethra, so you should not remove the rod before. We will remove the rod but making counterforce with the ring. Clean the area and put on your diaper. Now there will be a constant trickle 24/7. 5- To remove the stent, you have to insert the rod up to the previously made mark and exert a counterforce from the ring. Once the rod is fully inserted, pull the stent out. Problems and other issues - Remember to sterilize everything before and after each use, as well as wash your hands. - Finding the Malecot catheter can be a problem, but there are some medical providers who ship to individuals. You can talk to some Chinese Alibaba suppliers to order samples to your country (https://www.alibaba.com/product-detail/Tianck-malecot-nephrostony-tube-set-disposable_1600109415473.html) - The ring used should be as thin as possible so that it does not cause discomfort and does not block the stent, but it is important that it be wide enough so that it does not migrate into the urethra. - I have another design based on a Foley catheter that does not require a rod, is easier to get and is cheaper, but it is necessary to use a larger size so that the ring does not interfere with the opening of the stent. If you are interested, I can expand this guide with this design.

Hello I'm new here i wanted to share thoughts on my diaper plays. I have achieved a type of incontinence which i feel is the most difficult to manage, constantly dribbling urine from the use of stent. It really is a mind bending experience of constantly feeling rush out of your penis with every small movement you make. You can try to suck it up to stop the urine like you did a few moments ago before the installation but it just won't stop. All you do all day is spurt spurt spurt into your diaper. This experience is really intense and completely changes your lifestyle if you wear it for a long time. You always have to wear a diaper! That much is pretty clear, but issues arise in those small gaps you don't wear it. When changing diapers you have to put your new diaper under the old one and do a quick swap. This maneuver is awkward as hell. Also I really like to stay clean in my crotch area and always feel like having a quick rinse inbetween changing diapers. But with constantly dribbling incontinence there's no point in having a quick cleaning, it literally only lasts 1 minute before you're wet and soggy again. I forget to mention the main issue of dribbling type of incontinence which i am sure everyone agrees is the capacity detection. Your all fine sitting in your chair working or playing on your computer and whoos, you now have a soggy chair because forgot to change your diaper 30 mins ago. But theres no way to tell it was 30 mins ago, because this wildly depends on your water intake since the last change. Another issue i have found is when taking a shower or bath. You really feel good cleaning your whole body even though your peeing constantly while doing so which i don't have an issue with as it doesn't really matter on the shower. But as soon as you step out the bathroom you have to control your dribble. You can't even take a slow drying with your towel and enjoying the sunlight. Moisturizing your skin and such. But nope! go back into diapers as soon as possible if you don't want urine stained floor. You can really miss those small moments of peace. I would love to hear your experiences as well if you have or achieved this type of incontinence. It may seem abit like a rant but i do really love the experience when you temporarily have this type of incontinence. Hope you guys enjoy it too, i can really sympathize with people who do have this type of incontinence.

I was inspired by the folks over in Incontinent-Desires. There's a rather industrious group there making stents for creating incontinence as opposed to using catheters. So I just extrapolated a bit, and added a little modern/slightly futuristic tech. I hope ye enjoy.

I haven't posted much lately, crazy busy with work and preparation for my daughters wedding. I knew if I thought enough and developed the right techniques, I'd come up with the appliance. Unfortunately, the description will have to do for now. The computer is being stubborn and I can't upload pics from my phone. Start with a straight vinyl catheter. I use 16FR. You need a heat gun, steel ruler, razor knife, clamps, and a pair of pliers with a round notch approximately 14FR. I'm using a pair of electrical pliers that have a pair of smooth round notches in the jaws. Pre warm pliers with heat gun. Hold catheter in plier notch near hole where inner sphincter is. Heat inner side next to pliers VERY SLOWLY and tubing will start to swell. Use slight pressure to mushroom tubing against flat edge of pliers. The pliers will protect the part of the tubing from the heat and shrink it's diameter slightly. Measure from the narrowing about 6-8 cm and cut the tubing lenghtwise starting with a long sloped cut. Place the ruler on edge in the U and clamp down. Cut on both sides leaving a thin tail. Trim smooth and cut to final length. For me it's 19cm. I'll upload a pic a soon as I can.

If you've used a stent or similar design I'd like to hear how you're making out with diapers and 24/7 wetting. The reason I bring this up is I've found it much harder to get good value out of